SED-3ZSJ-T — Electrical Type
لا تزال ترجمة الوصف الكامل لهذا الطراز قيد العمل. راجع التفاصيل بالإنجليزية أو اطلب المعلومات من فريقنا. English
SED-3ZSJ-T vacuum powder feeder (electrical type). Whirlpool-pump-driven (3.0 kW, 380V 50Hz 3-phase) vacuum conveyor that lifts powder/granule material from drums or floor-level containers up to mixers, reactors, hoppers
مبدأ العمل
Whirlpool pump creates negative pressure in the Ø290 mm stainless-steel hopper. Material is sucked from the source through the stainless-steel suction nozzle and Ø51 mm PVC steel-wire hose into the hopper, where air/material separation occurs at the film-covered filter(Ø50 × 200 mm PE). After each feed cycle, a reversing valve switches to unloading: the pneumatic discharge door opens to drop material into the receiving equipment, then compressed-air back-blow cleans the filter. Level meter auto-starts when material falls below setpoint, auto-stops when above setpoint.
المواصفات الفنية
المواصفات
الأبعاد
المواد
المكونات
meta
التشغيل
البيانات الفيزيائية
الخصائص الرئيسية
التطبيقات
القطاعات
العلامات التجارية للمكونات
التنظيف والصيانة
After each batch or material change:(1) Open clip, remove hopper cover;(2) Remove filter — blow off powder with compressed air, then clean with warm water ≤80°C and a soft brush only(no hard brushes, which reduce filter accuracy); (3) Dry filters naturally or in oven ≤50°C until fully dry before reinstalling;(4) Open clips and rinse hopper with clean water;(5) Reassemble per assembly diagram.